ChemLink

E-Curbs (Single Sets and Pieces)

In stock
Check for local delivery
As low as $3.98
Financing Available for orders over $1,000
E-Curb precast form components are composed of light weight nylon resin. The E-Curb is 2-inches high and is available in a variety of shapes and sizes. Standard sizes include bisected circular pieces with inside diameters of 3, 4, 5, 6 or 9 inches; corner pieces with a 2-inch radius; straight pieces in 3-inch or 8-inch lengths; and a 4.5” x 3.4” rectangle. The outer surface is impervious to ice, corrosion, UV (ultraviolet) light and ponding water.

INSTALLATION
Bonding surfaces should be clean, dry and free from all contamination that may inhibit the sealant’s performance. Remove all previously applied caulk, mastic, cement, asphalt, and other contaminants from penetrations with a wire brush. Brush away all gravel or loose granules. Isopropyl alcohol is an effective cleaner for surface preparation. Please contact customer service for application guidelines with temperatures below 32°F (0°C). Do not use on TPO without the use of TPO primer. Do not use on Hypalon. Smooth APP membranes require a granulated target. This product sets rapidly upon exposure to moisture. Please refer to data sheet for step-by-step installation guidelines.
More Information
SKU CHE-F13XX
Manufacturer ChemLink
Height 0in
Length 0in
Weight 0lb
Country of Manufacture
RAPID INSTALL 'slip-fit' light weight curb design

SERVICE TEMPS wide range -40F to 200F

1 PART FEATURE accommodates movement

LABOR SAVINGS no flashing required